Carver Sound and Audio

Carver Amplifier and Carver Audio Product Specs and Information
December 20, 2009

PSC-50

Carver PSC-50
Frequency response 20 - 20kHz +-1dB.
Maximum Output 6V RMS
Total Harmonic Distortion 0.008% 20Hz-20kHz at 2V RMS out
S/N-IHF A-Weighted 80dB below 5mV input leve
Phono sensitivity for 0.5V@1kHz 2.5 mV
Dimensions (HxWxD,inches) 1.75" (1U) x 19" x 12.75"
 
Architect's and Engineer's Specifications
The preamplifier shall be capable of stereo program feed to two zones with independent source selection and volume control for each zone. Audio source selection, power on/off, volume and muting shall be operable from both the front panel and from a supplied wireless infra-red remote control transmitter. The preamplifier shall include the following stereo inputs: 7 line level (includes 2 tape monitor inputs) and one moving magnet phono input. Included stereo outputs shall be: 1 main zone preamplifier output, 1 remote zone preamplifier output ant 2 fixed level tape recording outputs.
The preamplifier shall feature independent volume control for each zone. The volume control shall be motorized control capable of being operated manually from the front panel, or by remote control. The remote zone volume control shall be a solid state electronic attenuator type capable of being operated from front panel up/down pushbuttons, or by remote control.
The main zone preamplifier section shall incorporate Carver Sonic Holography special enhancement circuitry.
Additional front panel controls for the main zone shall include: balance control, bass and treble control, loudness compensation on/off, muting on/off and hologram on/off. A headphone jack shall be included for monitoring program output to the main zone.
Frequency response shall be 20Hz 20kHz within 0.5dB. Signal to noise ratio for line level sources shall be 95dB below 1 volt RMS output (A Weighted). For Phono source, signal to noise ratio shall be 80dB A Weighted relative to 5 mV RMS input level. Total harmonic distortion shall be 0.008% or less at 2V RMS output. Output impedance at preamps outputs and tape outputs shall be approximately 680? and recommended shall be 2500 ? or greater.
Dimensions of the unit shall be: height 1.75" (45 mm), width 19" (480 mm), depth of chassis 12.75" (324 mm), and overall depth 14.75" (375 mm). The unit shall be capable of being mounted in a stand

Features
• Independent source selection for two separate stereo outputs.
• Independent remote/manual volume.
• 7 line level stereo inputs/2 stereo outputs.
• Moving magnet phono pre-preamplifier stage.
• 2 signal processor/tape loops with debugging.
• 2 band tone controls and loudness equalization.
• Balance & master gain control.
• Carver exclusive Sonic Holography® special enhancement circuitry.
• Full function infrared remote control.
• Headphone monitor jack.
• 98dB S/N IHF A-Weighted.
• 20-20kHz ±0.5dB frequency response.
• 0.008% line level THD.

Search for Carver products on eBay